Printable Platter Speed Disk

Printable Platter Speed Disk – Better results can be attained using the turntabulator app. These discs will allow you to check the speed of your turntable. (176.4 kb/s) of usable audio data) and thus must vary the disc's rotational speed from 8 hz (480 rpm) when reading at the innermost edge. What's the speed of your turntable?

Vintage 14" Hard Drive Disk Platter Dec Digital Equipment Corporation

How does a turntable strobe work? Place the lamp so the light is shining on the disc and set the speed selector to the. Strobe discs can be downloaded for free from many sites on the internet and require a strobe light to determine if the turntable is spinning at the correct speed.

It Covers The Following Speeds:

Free turntable speed check strobe. To use the strobe light method, you’ll need to download a strobe disc from the internet and print it off. The platter or disc is marked with dots or lines.

Just Put A Little Marker On The Platter.

If you suspect a marginal motor, belt or excess drag pulling on the motor and belt, the plattertracker™ can assist your diagnosis. Page 1 of 1 start over lowest. Feickert platterspeed and test disc.

A Flash Illuminates Each Individual Line As It Passes.

Download free strobe disk (in adobe pdf format) enjoy! Instructions (1) select the correct mains frequency for your country (2) print out the speed disc to the desired size (3) cut a 7.25mm hole in the centre for the spindle (4) view the disc under standard tungsten room lamp (5) bars should appear stationary Sf bay area, usa if you've got three minutes to spare, you can count revolutions, 33 1/3 rpm = 100 revolutions in 3 minutes.

I Printed Out A Strobe Disc From The Vinyl Engine Site And Get The Same Results.

The strobe disc is unique because instead of bars it has the rotational speed printed as numbers that you can read directly from the disc. Most commonly at 100 (50hz version) or 120 times a second (60hz version). I hope that i can get this motor to work because it is dead silent!

Just Download And Print Out The Strobe Using Printer.

Print and cut out the speed disc that matches the lamp you'll be using. Again, they should be printed to scale, and be sure to use the disc suitable for the electricity supply in your country (50hz in the uk). 16.66, 33.33, 45, and 70.59 to 90 rpm in 15 bands.

A Strobe Light Flashes Rapidly.

Using a strobe disc or a mobile app. Punch a hole in the marked center of the disc and place it over the spindle of your turntable platter. Whether it should be 16, 33.3, 45 or 78rpm you will know your record platter's speed to within 0.1 rpm's.